Seat Leon >> Rear towing eye

Fig. 224 Rear bumper on right: remove the lid.

Fig. 225 Right side of the rear bumper: towing
eye screwed in.
The mounting housing for the screw-in rear towing eye on your Seat Leon is positioned on the right side of the rear bumper behind a removable access lid ››› Fig. 224.
Please note that vehicle models factory-equipped with an integrated towing bracket (tow hitch) do not feature any threaded housing for the screw-in towing eye behind this lid. In such cases, the factory tow hitch itself must be utilized or deployed for towing operations.
Always carefully observe and follow all general safety instructions and guidelines regarding vehicle towing.
Assemble the rear towing eye (cars without a factory-equipped towing bracket)
- Take the towing eye out of the vehicle tool kit stored within the luggage compartment.
- Press firmly on the lower edge or side of the bumper lid ››› Fig. 224 to unclip and release it from the fascia.
- Remove the lid completely and let it dangle safely from the vehicle by its tether.
- Screw the towing eye into the exposed threaded housing by turning it anticlockwise ››› Fig. 225, ››› until it reaches the stop. Use a suitable strong object to completely and securely tighten the towing eye in its housing.
- After towing is finished, unscrew the towing eye by turning it clockwise with a suitable tool.
- Replace the cover lid and press on it until the retaining tab snaps firmly back into the bumper structure.
- Clean the towing eye if necessary and return it to its designated spot in the luggage compartment tool kit.
NOTICE
- The towing eye must always be completely and firmly tightened before any load is applied. Otherwise, it could loosen or release while towing and tow-starting.
- If your Seat Leon is factory-equipped with an integrated towing bracket, it is only permissible to tow using a rigid tow bar if that bar has been specifically engineered and approved for installation with a tow hitch. If an unsuited tow bar is attached, both the tow hitch and vehicle chassis components can suffer severe damage. Instead, a flexible tow rope should be preferred.
Front towing eye
Fig. 222 Front bumper on right: remove the lid.
Fig. 223 Right side of the front bumper: towing
eye screwed in.
The internal mounting housing for the removable front towing eye on your Seat Leo ...
Fuses
Introduction
In the complex electrical architecture of your Seat Leon, a single fuse can protect and be assigned to several different electrical components. Likewise, a single electrical component or ...
See also:
Locking and unlocking the vehicle
The remote control key can be used to lock and unlock the
vehicle from a distance.
Fig. 63 Assignment of
buttons on the remote
control key
Fig. 64 Range of the
Using the button fig. 63 ...
