Seat Leon >> Activate and deactivate front passenger airbag

SEAT Leon (4th Generation, KL; 2020+) Owner’s Manual / Safety / Airbag system / Activate and deactivate front passenger airbag

Key-operated passenger airbag deactivation switch located on the side of the dashboard in the Seat Leon
Fig. 28 Switch for activating and deactivating the front passenger airbag.

Overhead roof console featuring the passenger airbag status indicator lamps in the Seat Leon
Fig. 29 On the roof console: passenger airbag deactivation control lamp.

You should only deactivate the front passenger airbag if it is absolutely necessary to install a rear-facing child safety seat on the front passenger seat of your Seat Leon.

SEAT strongly recommends mounting child restraint systems on the rear passenger seats whenever possible to avoid needing to deactivate the front passenger airbag.

When the front passenger airbag is manually turned off, only that specific front passenger airbag module is deactivated. All other airbags distributed throughout the vehicle cabin remain fully active and ready to deploy.

Deactivate and activate the front passenger airbag

  • Switch off the vehicle ignition completely.
  • Open the front passenger-side door to access the dashboard side panel.
  • Extract the removable mechanical key blade from your vehicle master key fob.
  • Insert the key blade fully into the slot provided in the front passenger airbag deactivation switch module ››› Fig. 28. Approximately three-quarters of the key blade should enter, stopping when fully seated.
  • Carefully turn the key to rotate the switch position to Airbag deactivation icon position (to deactivate) or to Airbag activation icon position (to activate). If you encounter mechanical resistance, verify that the key blade has been pushed into the slot all the way.
  • Close the front passenger door securely.
  • When deactivating the passenger airbag, switch the ignition on and inspect the overhead console to verify that warning lamp Passenger airbag OFF warning lamp icon remains continuously lit ››› Fig. 29.
  • When reactivating the passenger airbag, switch the ignition on and verify that the deactivation lamp Passenger airbag ON indicator lamp icon does not light up, while the active status lamp Passenger airbag status lamp icon illuminates for 60 seconds before turning off.

DANGER Always turn off the vehicle ignition before attempting to disable or enable the front passenger airbag! Failing to do so can trigger a functional electronic fault in the vehicle's airbag control network.

WARNING

  • The vehicle driver bears full personal responsibility for correctly switching the front passenger airbag on or off according to current transport requirements.
  • Never leave the mechanical key inserted in the airbag deactivation switch, as it could easily suffer physical damage or inadvertently alter the airbag state while driving.
  • If an airbag is deactivated for a specific transport need, make sure to reactivate it promptly as soon as adult passengers occupy the seat so that it can resume its life-saving protective function.
    Front airbags
    Fig. 26 Driver's airbag in the steering wheel. Fig. 27 Front passenger airbag located in the dash panel. The driver's front airbag is securely housed inside the steering wheel hub, while th ...

    Central airbag
    Fig. 30 In the inner padding of the driver's seat backrest: central airbag. Fig. 31 Fully inflated central airbag (deployment zone). The central airbag is installed for the front seating p ...

    See also:

    Removing and installing GPS aerial
    Special tools and workshop equipment required Release lever - U30800- removing Switch off ignition and all electrical equipment. Vehicles without access and start authorisation system ...