Seat Leon >> Mouldings / trims / extensions
SEAT Leon Service and Repair Manual / General body repairs, exterior / Exterior equipment / Mouldings / trims / extensions
- Exploded view - water deflector
- Exploded view - side member trim
- Removing and installing sill panel trim
- Removing and installing wheel arch trims
- Remove and install heat shield for luggage compartment floor
- Removing and installing heat shield for centre tunnel
- Removing and installing heat shield for propshaft
- Remove and install panel trim
- Removing and installing A-pillar trim
- Removing and installing trim panel for B-pillar (front door)
Renew the spoiler mounting
Special tools and workshop
equipment required
Electric cutter - SAT
1561A-
Cable holder knob - VAG
1351/1-
Knife 181 - VAS 1561/18-
Adhesive strip remover - VAS 6349-
Removin ...
Exploded view - water deflector
Note
The sequences below describe the processes for removal and installation for
the right side of the vehicle. The
corresponding sequences for the left side are similar with the exception that,
...
See also:
Running-in tyres and brake pads
New tyres should be run-in carefully for the first 500 km. New
brake pads should be run-in carefully for the first 200 km.
During the first 200 km, you can compensate for the reduced braking effect
...
