Seat Leon >> Changing a wheel
Change the wheel as described below
– Pull off the hub cap. See fig. 154.
– Slacken the wheel bolts
– Raise the car with the jack in the corresponding zone
– Take off the wheel and then put on the spare wheel
– Lower the vehicle.
– Tighten the wheel bolts firmly in diagonal sequence with the box
spanner
– Replace the hub cap.
Preparation work
What you must do before changing a wheel.
– If you have a flat tyre or puncture, park the vehicle as far away
from the flow of traffic as possible. Choose a location that is as
level as possible. ...
After changing a wheel
After changing the wheel there are still tasks to complete.
– Put the tools and jack back in the luggage compartment.
– Place the wheel with the defective tyre in the luggage compartment
and se ...
See also:
Window shaft seal on inside of rear door:
removing and installing
Special tools and workshop equipment required
Torque wrench - V.A.G 1331-
Wedge - T10039/1-
Note
The sequences below describe the processes for removal and
installation for the ...