Seat Leon >> Adjusting set speed*

The speed can be altered without touching the accelerator or the brake.

Fig. 127 Turn signal and

Fig. 127 Turn signal and main beam lever: switch and rocker switch for CCS

Setting a higher speed
– Press the upper part RES+ of the rocker switch  fig. 127 A to increase the speed. The vehicle will continue to accelerate for as long as you keep the rocker switch pressed. When you release the switch, the new speed is stored.

Setting a lower speed
– Press the lower part SET– of the rocker switch A to reduce the speed. The vehicle will automatically reduce its speed for as long as you keep the switch pressed. When you release the switch, the new speed is stored.

When you increase speed with the accelerator and then release the pedal, the system will automatically restore the set speed. This will not be the case, however, if the vehicle speed is more than 10 km/h higher than the stored speed for longer than 5 minutes. The speed will have to be stored again.

Control of the set speed is switched off if you reduce speed by depressing the brake pedal. You can reactivate the control by pressing once on the upper part of the rocker switch RES+  fig. 127 A.

WARNING

It is dangerous to use a set speed which is too high for the current road, traffic or weather conditions. Risk of accident.

    Setting speed*
    Fig. 126 Turn signal and main beam lever: switch and rocker switch for CCS – Press the lower part SET of the rocker switch  fig. 126 A once briefly, when you have reached the speed you wi ...

    Switching off the system temporarily*
    Fig. 128 Turn signal and main beam lever: switch and rocker switch for CCS The cruise control system will be switched off in the following situations: • if the brake pedal is depressed, • i ...

    See also:

    Location overview - Antenna systems
    Location overview - Antenna systems, 2-door vehicle - Frequency modulation (FM) frequency filter in positive wire - R179- Removal and installation - Screw 2 Nm - Aerial ...