Seat Leon >> Removing and installing front parking aid senders
SEAT Leon Service and Repair Manual / Electrical system / Lights, bulbs, switches - exterior / Parking aid / Removing and installing front parking
aid senders
Removing
- Switch off ignition and all electrical consumers.
Vehicles without access and start authorisation system
- Remove ignition key, if fitted.
Vehicles with access and start authorisation system
- Store the ignition key outside the vehicle to prevent the ignition from being switched on unintentionally.
Continued for all vehicles
- Remove front bumper cover .
- Pull-off the electrical connection -1- in the sensor.
- Press on both lugs in the -direction of the arrow- and press the sender -2- from the outside to the inside.
Installing
Installation takes place in reverse order.
Removing and installing rear parking aid senders
Removing
- Switch off ignition and all electrical consumers.
Vehicles without access and start authorisation system
- Remove ignition key, if fitted.
Vehicles with access and start authorisation system
- Store the ignition key outside the vehicle to prevent the ignition from being switched on unintentionally.
Continued for all vehicles
- Remove back bumper cover .
- Pull-off the electrical connection -2- in the sensor.
- Press on both lugs in the -direction of the arrow- and push the sender -1- from the outside to the inside.
Installing
Installation is carried out in the reverse sequence; note the following:
Removing and installing warning buzzers
for back parking assist H15
Removing and installing warning buzzers
for back parking assist H15
Removing
Switch off ignition and all electrical consumers.
Vehicles without access and start authorisation system
Remov ...
See also:
Exploded view - control unit and hydraulic
unit
Exploded view - control unit and hydraulic unit, LHD
- ABS control unit - J104-
Do not unplug connector
before completing
self-diagnosis
Switch off ignition before
detaching conne ...