Input shaft oil seal: replacement

Special tools and workshop equipment required Pressing-off lever - T20143/1- Thrust pad - T40008- Sealing grease For grease allocation, refer to - Electronic parts catalogue (E ...

Assembly overview - output shaft

Note When installing new gears or new input shaft, refer to - Electronic parts catalogue (ETKA) and technical data. Install all bearings, synchromeshed gears and synchro-rings on output ...

See also:

Wheel assignment
6 J x 15 Note Always observe the allocation of wheels and tyres to the respective engines, which are listed in the overview table. Bolt hole diameter: 112 mm Number of wheel bolt holes: 5 Steel ...