Seat Leon >> Jump leads

The jump lead must have a sufficient wire cross section.

If the engine fails to start because of a discharged battery, the battery can be connected to the battery of another vehicle to start the engine.

Jump leads Jump leads must comply with the standard DIN 72553 (see manufacturer's documentation). The wire cross section must be at least 25 mm2 for petrol engines and at least 35 mm2 for diesel engines.

Note
 • The vehicles must not touch each other, otherwise electricity could flow as soon as the positive terminals are connected.
• The discharged battery must be properly connected to the vehicles electrical system.

    How to jump start
    Fig. 180 How to connect the jump leads In  fig. 180, the flat battery is A and the charged battery B. Jump lead terminal connections – Switch off the ignition on both vehicles . 1. Co ...

    See also:

    Before starting every trip
    The driver bears the responsibility for his passengers and the operational worthiness of the vehicle. For your own safety and the safety of your passengers, always note the following points before ...