Seat Leon >> Removing and installing rear bumper aerial for entry and start authorisation - R136-
SEAT Leon Service and Repair Manual / Electrical system / Lights, bulbs, switches - exterior / Entry and start authorisation / Removing and installing rear bumper
aerial for entry and start authorisation -
R136-
Removing
- Switch off ignition and all electrical consumers.
Vehicles without access and start authorisation system
- Remove ignition key, if fitted.
Vehicles with access and start authorisation system
- Store the ignition key outside the vehicle to prevent the ignition from being switched on unintentionally.
Continued for all vehicles
- Remove rear bumper cover.
Note Depending on the model, the aerial in the rear bumper for access and start authorization - R136- is aligned the other way .
- Unlock tabs -3-.
- Turn the luggage compartment aerial for entry and start system - R136- -2- slightly in the -direction of arrow A-.
- Pull out the luggage compartment aerial for entry and start system - R136- -2- in the -direction of arrow B- from the retainers -3-.
- Release connector -1- and unplug.
Installation
Install in reverse order.
Removing and installing luggage compartment aerial for entry and start system - R137-
Special tools and workshop equipment required Lever - 80 200- Removing Switch off ignition and all electrical consumers. Vehicles without access and start authorisation system Remo ...Automatic headlight range control
Removing and installing headlight range control unit Removing Switch off ignition and all electrical consumers. Vehicles without access and start authorisation system Remove ignition key, ...See also:
How to jump start
Fig. 180 How to connect
the jump leads
In fig. 180, the flat battery is A and the charged battery B.
Jump lead terminal connections
– Switch off the ignition on both vehicles
.
1. Co ...