Seat Leon >> Mouldings / trims / extensions
SEAT Leon Service and Repair Manual / General body repairs, exterior / Exterior equipment / Mouldings / trims / extensions
- Exploded view - water deflector
- Exploded view - side member trim
- Removing and installing sill panel trim
- Removing and installing wheel arch trims
- Remove and install heat shield for luggage compartment floor
- Removing and installing heat shield for centre tunnel
- Removing and installing heat shield for propshaft
- Remove and install panel trim
- Removing and installing A-pillar trim
- Removing and installing trim panel for B-pillar (front door)
Renew the spoiler mounting
Special tools and workshop
equipment required
Electric cutter - SAT
1561A-
Cable holder knob - VAG
1351/1-
Knife 181 - VAS 1561/18-
Adhesive strip remover - VAS 6349-
Removin ...
Exploded view - water deflector
Note
The sequences below describe the processes for removal and installation for
the right side of the vehicle. The
corresponding sequences for the left side are similar with the exception that,
...
See also:
Exhaust gases inspection (diesel engines)
using the exhaust gas analyser -SAT 3500A-
Special tools and workshop equipment required
Exhaust gas analyser - SAT 3500ACheck
Check prerequisites
Allow the engine to reach service temperature.
Oil temperature should be above 70 ...
