Seat Leon >> Remove and install securing strip

Securing strip, vehicles with 3 and 5 doors: removing and fitting

Special tools and workshop equipment required

  • Torque wrench - V.A.G 1331-

Bumpers

Removing

  • Remove the bumper trim.
  • Release connector -1- and unplug.

Note Do not observe items -2- and -3-, the -arrow A- and the -arrow B-.

Bumpers

  • Loosen the clips -1- of the wiring harness.
  • Remove bolts -2- and cross member.

fitting

Installation is done in reverse order of removal operations.

  • Use the tightening torque of the screws.

Bumpers

Securing strip, model ST: remove and install

Special tools and workshop equipment required

  • Torque wrench - V.A.G 1331-

Bumpers

Removing

  • Remove the bumper trim.
  • Loosen the clips -1- of the wiring harness.
  • Remove bolts -2- and cross member.

fitting

Installation is done in reverse order of removal operations.

  • Use the tightening torque of the screws.

Bumpers

    Exploded view - impact bar
    Cross brace of the rear bumper cover, 3 and 5 door: assembly overview - Cavity wax - AKR.308.SP5- Note To prevent water penetration - Tight spreader block 5 off DANGER ...

    Removing and installing bumper cover
    Rear bumper trim, three and five-door models: remove and install Special tools and workshop equipment required Torque wrench - V.A.G 1331- Removing Open the tailgate. Remove tail ligh ...

    See also:

    Self-adhesive, side emblems (3 and 5- door models): replacing
    Company badge "ITECH" Special tools and workshop equipment required Hot-air blower - SAT 1416- Digital thermometer - SAT 4013- Thrust piece - T20098- Release lever - U 30800- Adhesive ...