Seat Leon >> Removing and installing actuator
SEAT Leon Service and Repair Manual / General body repairs, exterior / Bonnet, rear lid / Tailgate / Luggage lid / Removing and installing actuator
Special tools and workshop equipment required
- Torque wrench - V.A.G 1331-
Removing
- Open the tailgate.
- Remove lower tailgate trim.
- Detach connector -4-.
- Loosen nut -3-.
- Turn the retaining clips in the direction of the -arrows- and remove the rear handle -5-.
- Pull off the handle.
fitting
Fit in reverse order from removal, remembering the following:
Caution Before closing the tailgate, check that the unlocking components are operating. |
Adjusting rear lid
Special tools and workshop equipment required Torque wrench - V.A.G 1331- Release lever - 80 200- Adjustment gauges - 3371- Note For the basic setting of the rear lid, the ...Removing and installing hinges
Special tools and workshop equipment required Torque wrench - V.A.G 1331- Release lever - 80 200- Removing Note The sequences below describe the processes for removal and installat ...See also:
Safety notes on using seat belts
If seat belts are used correctly, they can reduce the risk of
injury in an accident.
– Always wear the seat belt as described in this booklet.
– Ensure that the seat belts can be fastened at al ...