Seat Leon >> Assembly overview - bonnet

Bonnet, rear lid

  1. - Fixed rubber limiters
    • 2 off
  2. - Bonnet seal
    • In the middle
    • 1x
  3. - Bonnet seal
    • On the side
    • 2 off
  4. - Adjustment buffer
    • Using the adjustment catches, the height of the bonnet can be adjusted in relation to the wings
    • 2 + 2 each
  5. - Bonnet sound proofing
    • Fixed by retaining clips
  6. - Hinge for bonnet
  7. - Nut
    • 2 + 2 each
    • 24+- 2 Nm
  8. - Bolt.
    • 2 + 2 each
    • 24+- 2 Nm
  9. - Retaining clip
    • 5 off
  10. - Front bonnet support rod
  11. - Engine compartment noise insulation
    • Depending on the version
  12. - Plenum chamber cover
  13. - Nut
    • 1 + 1 each
    • 9+- 1 Nm
  14. - Expansion rivet
    • 1 + 1 each
    • Always replace.
  15. - Grille below windscreen
  16. - Quick locking nut
    • 3 off
  17. - Retaining clip
    • To fix the noise insulation of the plenum chamber cover
    • 3 off
    • Open with screwdriver
    • Always replace.
  18. - Soundproofing on water box
    • Depending on the version
  19. - Securing cap
    • To fix the noise insulation of the plenum chamber
    • 2 off
  20. - Retaining clip
    • For attaching the bonnet noise insulation
    • 5 off
    • Open with screwdriver
    • Always replace.
  21. - Air duct grille
  22. - Air duct grille cover
  23. - Separator
    • 1 + 1 each
    • Removing and fitting
  24. - Plenum chamber seal
  25. - Bonnet
    • Adjusting
    Bonnet
    ...

    Exploded view - Bowden cable
    - Bolt. 2 off 10+- 1 Nm For fastening the release lever Item 2 - Release handle Removing Unthread the bolts -2- and remove the release lever. Adjusting: T ...

    See also:

    Correct adjustment of head restraints
    Properly adjusted head restraints are an important part of occupant protection and can reduce the risk of injuries in most accident situations. Fig. 87 Viewed from in front: Properly adjusted h ...