Seat Leon >> Removing and installing gear knob
SEAT Leon Service and Repair Manual / 5-speed manual gearbox 0AH / Controls, housing / Selector mechanism / Removing and installing gear knob
Special tools and workshop equipment required
- Hose clip pliers - V.A.G 1275 A-
- Wedges - T10383-
Removing
- Using removal wedge -T10383/1- , carefully pry gear lever boot off centre console insert -arrows-.
- Pull boot up and over gear knob.
- Open clip -arrow- and pull off gear knob together with boot.
Installing
Carry out installation in the reverse sequence, noting the following:
- Insert gear knob with the dust seal into the gear level all the way to the stop.
- Attach gear knob with O-type clip -arrow- (previous Fig.) to gear lever. For doing this use the hose clip pliers - V.A.G 1275 A- .
Exploded view - selector mechanism
Note Lubricate bearing positions and sliding surfaces. For grease allocation. - Selector shaft with cover - Oil seal Must be renewed after fitting - Shoe - Gate relay ...Gear selection mechanism: removing and fitting
Special tools and workshop equipment required Torque wrenches - V.A.G 1331- Removing Disconnect battery . Remove gear knob and gaiter . Remove centre console mounting . Remove noise ...See also:
Removing and installing bearing bush
Removing
Push driver's seat as far back as possible.
Move steering wheel up as far as it will go, making use of full
range of steering column adjuster.
Vehicles with knee airbag
Remove ...