Seat Leon >> Exploded view - selector mechanism
SEAT Leon Service and Repair Manual / 5-speed manual gearbox 0AH / Controls, housing / Selector mechanism / Exploded view - selector mechanism
Note
- Lubricate bearing positions and sliding surfaces.
- For grease allocation.
- - Selector shaft with cover
- - Oil seal
- Must be renewed after fitting
- - Shoe
- - Gate relay lever
- Equivalent
- Grease
- Installation position
- After installing, adjust selector mechanism
- Remove and install relay lever together with cable endpiece
- - Cable attachment
- To secure selection control cable to relay lever
- After installing, adjust selector mechanism
- Do not mix up. Cable end-pieces for gate selector cable to relay lever and gear selector cable to gearbox selector lever are different.
- Allocation
- Remove from the gate relay lever
- Press onto relay lever
- - Gear selection rod
- Grease
- Install so that gap in splines aligns with selector shaft
- Installation position
- After installing, adjust selector mechanism
- - Hexagon nut
- Tightening torque
- - Cable attachment
- To secure selection control cable to selection rod
- After installing, adjust selector mechanism
- Do not mix up. Cable end-pieces for gate selector cable to relay lever and gear selector cable to gearbox selector lever are different.
- Allocation
- - Retaining clip
- Must be renewed after fitting
- - Gear selection control cable
- Connect to cable end-piece.
- Installation position
- - Gear selector cable
- Connect to cable end-piece.
- Installation position
- - Hexagon nut
- Installation position
- - Seal
- Between gear lever casing and vehicle underbody
- Renew after removing the selector housing.
- Self-adhesive
- Stick it onto the protective cover
- - Gear stick protective cover
- - Retaining clip
- Must be renewed after fitting
- do not damage the gear selector cables when disassembling
- Installation position
- - Hexagonal bolt
- 3 Units
- for cable support bracket
- 20 Nm
- - Cable support bracket
- After installing, adjust selector mechanism
- - Shift collar
- 3 Units
- Cable support bracket mounting on gearbox
- - Separation element
- 3 Units
- - Clip
Installation position: Gear shift mechanism
Note
Disconnect battery before working on selector mechanism in
engine compartment.
Removing and installing selector mechanism.
Arrow -A- Gear selection movement
Arrow -B- Gate selection m ...
Removing and installing gear knob
Special tools and workshop equipment required
Hose clip pliers - V.A.G 1275 A-
Wedges - T10383-
Removing
Using removal wedge -T10383/1- , carefully pry gear lever
boot off centr ...
See also:
Glazing
Windows, main components
- Windscreen
Note
The spare parts service only supplies
a windscreen with sealing lip,
which is compatible for vehicles with
and without sliding/tilting sunroof.
...
