Seat Leon >> Repairing steering box
SEAT Leon Service and Repair Manual / Running gear, axles, steering / Steering / Steering box / Repairing steering box
- - Right track rod ball joint
- Marked with "A"
- Removing and installing
- Installation position
- Corresponding to - Electronic parts catalogue "ETKA"
- - Nut
- To tighten and loosen the nut it is necessary to block the ball joint with a spanner
- 70 Nm
- - Clamp
- - Dust guard
- Must not be twisted after toe setting has been adjusted.
- Removing and installing
- - Clamp
- Renew
- Tightening
- - Connecting rod
- Removing and installing
- 100 Nm
- - Steering box
- Corresponding to - Electronic parts catalogue "ETKA"
- Removing and installing
- - Left track rod ball joint
- Marked with "B"
- Removing and installing
- Installation position
- Corresponding to - Electronic parts catalogue "ETKA"
- - Nut
- To tighten and loosen the nut it is necessary to block the ball joint with a spanner
- 70 Nm
- - Spring type clamp
- - Dust guard
- Removing and installing
- Check for damage
- Must not be twisted after toe setting has been adjusted.
- - Clamp
- Always renew after removing
- Secure new hose clip using locking pliers for steering box - VAS 6199-
- - Connecting rod
- Also replace the ball joint if damaged
- Removing and installing
- 100 Nm
Sensors
Removing and installing steering angle sender - G85-
Note
- The steering angle sender - G85- is a component of the steering box.
- It cannot be replaced separately.
- When the steering angle sender - G85- is defective, the steering box must be replaced.
Removing and installing track rod ball joint
Special tools and workshop equipment required Ball joint puller - T10187- Torque wrenches - V.A.G 1332- Removing Remove front wheel on affected side. Loosen nut -1-. Mark posi ...Brake system
...See also:
Description of side airbags
The airbag system is not a substitute for the seat belts.
Fig. 21 Side airbag in
driver seat
The side airbags are located in the backrest cushions of the driver seat
fig. 21 and the front ...