Seat Leon >> Removing and installing rear body acceleration sender - G343-

Special tools and workshop equipment required

  • Torque wrenches - V.A.G 1410-

Self-levelling suspension

Removing

  • Remove left side panel trim in luggage compartment.
  • Release electrical connector -1- and pull off.
  • Undo bolt -2- and remove rear body acceleration sender - G343- -3-.

Installing

Carry out installation in the reverse sequence, noting the following:

Self-levelling suspension

  • Insert rear body acceleration sender - G343- -1- so that lug -arrow A- engages into hole -arrow B-.
  • Perform basic setting of wheel damper electronics - Vehicle diagnostic tester.

Self-levelling suspension

Specified torques

Self-levelling suspension

    Removing and installing front body acceleration senders -G341- / -G342-
    Special tools and workshop equipment required Torque wrenches - V.A.G 1410- Removing Pull seal off entire length of plenum chamber cover. Unclip the filler piece. Unhook the clips -2- ...

    See also:

    Maintenance
    Technical data of the engines Petrol engines 1) Unleaded RON 91 can also be used, but will result in a slight loss of power. 2) Unleaded RON 91 can also be used, but will result in a slight ...