Seat Leon >> Safety instructions

Safety precautions when working on vehicles with a start/stop system

WARNING

All bolts and nuts must be fully tightened according to specifications before the vehicle is driven on public roads.

 

WARNING

There is a risk of an accident through an automatic engine start on vehicles with start/stop system.

  • On vehicles with an active start/stop system the engine may start automatically.
  • When working on the vehicle, it is therefore important to ensure that the start/stop system is deactivated (switch off ignition and switch on again if required).

Safety precautions when working on subframe

  • No welding or straightening work can be done on the support and guide elements of the wheel guide system.
  • Always renew corroded nuts and bolts.
  • Bonded rubber bushes can only be turned to a limited extent.

    Therefore, tighten the bolted connections of components with bonded rubber bushes only when the wheel bearing housing has been raised (unladen state).

    See also:

    Covering bi-xenon headlights for driving on the right
    Fig. 136 Right headlight Fig. 137 Left headlight On the right headlight, if you are changing from driving on the left-hand side to the right-hand side. On the left headlight, if you are ch ...