Seat Leon >> Removing and installing evaporator temperature sensor - G308-

Note Vehicles with air conditioner only, opening in heater is sealed off on vehicles with heater.

Removal:

  • Turn off the ignition and all electricity consumers.

Vehicles without access and start authorisation system

  • Remove ignition key, if fitted.

Vehicles with access and start authorisation system

  • Store ignition key outside the vehicle to prevent the ignition from being switched on unintentionally.

Continued for all vehicles

  • Remove glove compartment.
  • Use a narrow screwdriver to release the retainer tabs -arrows-.
  • Remove the evaporator temperature sensor - G308- -2- from the housing.
  • Detach the electrical connector -1-.

Installing

Installation is carried out in the reverse order.

Air conditioning system

    Removing and installing coolant pipes on heat exchanger
    Removing and installing coolant pipes at heat exchanger (Valeo) Note There are different designs and makes of heater and air conditioning unit. The individual components of the various heaters and ...

    Removing and installing condensate drain
    Removal: Turn off the ignition and all electricity consumers. Vehicles without access and start authorisation system Remove ignition key, if fitted. Vehicles with access and start author ...