Seat Leon >> Removing and installing refrigerant circuit pressure sender - G805-

SEAT Leon Service and Repair Manual / Heating and air conditioning / Air conditioning system / Refrigerant circuit / Removing and installing refrigerant circuit pressure sender - G805-

WARNING

Danger from refrigerant escaping under pressure! Freezing of skin and other body parts.

  • If when loosening the G805 refrigerant escapes for more than 1 second from the coolant line, the G805 must be retightened. The non-return valve in the refrigerant line is defective and must be replaced.
  • Evacuate the refrigerant and then open the refrigerant circuit immediately.
  • If more than 10 minutes have elapsed since evacuation and the coolant circuit has not been opened, evacuate the refrigerant again. Pressure builds up in the coolant circuit as a result of secondary evaporation.

Removal:

  • Detach the electrical connector -2-.
  • Screw out the pressure sender -1-.

Installing

Install in reverse order of removal; note the following.

Air conditioning system

Note Renew O-ring seal.

    Assembly overview - condenser
    Condenser, receiver - Condenser Removing and fitting - O ring Replace Moisten with refrigeration oil before fitting - Refrigerant piping - Bolt. 8 Nm - B ...

    Removing and installing refrigerant line with internal heat exchanger
    Special tools and workshop equipment required Air conditioner service station Engine bung set - VAS 6122- Removal: Turn off the ignition and all electricity consumers. Vehicles witho ...

    See also:

    Removing and installing door handle
    Special tools and workshop equipment required Hooks - 3438- Removing Remove the lock cover of the handle. Carefully pull handle -2- in direction -arrow a- and remove from mount -1-. ...