Seat Leon >> Interior light / front reading lamp unit: removing and installing
SEAT Leon Service and Repair Manual / Electrical system / Lights, bulbs, switches - interior / Controls / Interior light / front reading lamp unit: removing
and installing
Special tools and workshop equipment required
- Lever - U30800-
Removing
- Switch off ignition and all electrical consumers.
Vehicles without access and start authorisation system
- Remove ignition key, if fitted.
Vehicles with access and start authorisation system
- Store the ignition key outside the vehicle to prevent the ignition from being switched on unintentionally.
Continued for all vehicles
- Unlatch the snap tabs -arrow- with the lever - U30800- or a suitable screwdriver, and remove the back interior light/reading light from the roof trim taking care of the connection lines.
- Release and detach connector -arrow- and remove rear interior light - W43- .
- Release the 4 locking lugs -arrows- each of lens -1- and remove lens from interior light by lifting it straight upwards.
- Remove bulb -1- from holder.
Installing
Installation is carried out in reverse order.
Removing and installing interior light/ reading light (front)
Removing and installing interior light/ reading light (front), without alarm system Special tools and workshop equipment required Lever - U30800- Removing Switch off ignition and all el ...Button for tyre pressure control unit - E226- : removing and installing
Special tools and workshop equipment required Lever - U30800- Removing Switch off ignition and all electrical consumers. Vehicles without access and start authorisation system Remo ...See also:
Removing and installing over-centre
spring
Removing
Push driver's seat as far back as possible.
Move steering wheel up as far as it will go, making use of full
range of steering column adjuster.
If fitted, remove footwell cover on dr ...