Seat Leon >> Automatic headlight range control
SEAT Leon Service and Repair Manual / Electrical system / Lights, bulbs, switches - exterior / Automatic headlight range control
Removing and installing headlight range control unit
Removing
- Switch off ignition and all electrical consumers.
Vehicles without access and start authorisation system
- Remove ignition key, if fitted.
Vehicles with access and start authorisation system
- Store the ignition key outside the vehicle to prevent the ignition from being switched on unintentionally.
Continued for all vehicles
- Depending on the configuration, remove the knee airbag on driver's side .
- Remove footwell vent on driver's side .
- Unplug electrical connector -2- by pressing catch and turning retaining clip; then detach connector.
- Remove the expanding clips -2- and take out headlight range control unit -1- towards rear.
Installing
Installation is carried out in the reverse sequence; note the following:
- Insert fastener -2- in opening -3- on control unit -1-, as shown in illustration, and lock by turning 90º -arrow-.
Removing and installing rear bumper aerial for entry and start authorisation - R136-
Removing Switch off ignition and all electrical consumers. Vehicles without access and start authorisation system Remove ignition key, if fitted. Vehicles with access and start authorisa ...Towing bracket
...See also:
Checking the engine oil level
The engine oil dipstick indicates the level of the oil.
Fig. 144 Engine oil
dipstick.
Before opening the bonnet, read and observe the warnings
in
“Safety instructions on working in the engin ...