Seat Leon >> Removing and installing parking light bulb M1 / M3

Note

  • The illustrations show the change of bulb for daytime running lights and parking light on the left headlight. The change of the bulb for daytime running light and parking light on the right headlight is done as follows.
  • The headlight does not have to be removed.

Removing

  • Switch off ignition and all electrical consumers.

Vehicles without access and start authorisation system

  • Remove ignition key, if fitted.

Vehicles with access and start authorisation system

  • Store the ignition key outside the vehicle to prevent the ignition from being switched on unintentionally.

Continued for all vehicles

  • Rotate bulb holder -1- to the left remove it in the direction of the -arrow-.

Lights, bulbs, switches - exterior

  • Hold the bulb holder -1- tight and press on the bulb -2- and turn to the left in the direction of the -arrow-.
  • Remove bulb -2- from holder -1-.

Lights, bulbs, switches - exterior

    Removing and installing dipped beam bulb M30 / M32
    Note The following illustrations show renewal of the main beam bulb for the left headlight. The high-beam bulb in the right-hand headlamp is replaced in the same way. The headlight does not ...

    Installing and removing the power module for headlight J667 / J668
    Installing and removing the power module for headlight J667 / J668, left side Removing Switch off ignition and all electrical consumers. Vehicles without access and start authorisation system ...

    See also:

    Adhesive strips for headlights
    If you have to drive a right-hand drive vehicle in a left-hand drive country, or vice versa, the asymmetric dipped beam headlights will dazzle oncoming traffic. To prevent dazzling, you must ap ...