Seat Leon >> Removing and installing spray jets

Removing

  • Switch off ignition and all electrical consumers.

Vehicles without access and start authorisation system

  • Remove ignition key, if fitted.

Vehicles with access and start authorisation system

  • Store the ignition key outside the vehicle to prevent the ignition from being switched on unintentionally.

Continued for all vehicles

  • Unclip the windscreen spray jet from the front of the flap -1- -arrow-.

  • Release the safety lock -3- in -the direction of the arrow- and remove the washer fluid hose -2- from the wash water spray jet.
  • If present, disconnect electrical connector -1-.

Windscreen wash/wipe system

Installing

Installation is carried out in the reverse sequence; note the following:

  • When pushing on the washer fluid hose, take care that you can hear the retaining clips locking in to the connection of the washer fluid hose.
  • Insert spray jet in bonnet.
    Removing and installing windscreen washer pump
    Installing and removing the washer pump, vehicles without additional left cooler Special tools and workshop equipment required Rear shelf - T20173- Removing Place the vehicle on a lift ...

    Jet adjustment
    WARNING Never clean the nozzles using any objects. To install the conducts, do not use a needle or similar object under any circumstances, as it could damage the jet water ...

    See also:

    Fitting location overview - front servomotors
    Installation location overview - front control motors, manually controlled electric air conditioning system - Servomotor for temperature flap - V68- With potentiometer for temperature f ...