Seat Leon >> Wheel trims

The wheel trims must be removed to gain access to the wheel bolts.

Fig. 154 Changing a

Fig. 154 Changing a wheel: Removing the wheel trim

Removing
 – Insert the extraction hook from the tools into the designated ring, located in one of the bolt hole covers of the wheel cover  fig. 154.
– Pull off the hub cap.

    After changing a wheel
    After changing the wheel there are still tasks to complete. – Put the tools and jack back in the luggage compartment. – Place the wheel with the defective tyre in the luggage compartment and se ...

    Wheel covers*
    The wheel covers must be removed for access to the wheel bolts Removing – Remove the wheel cover using the wire hook. – Hook this into one of the cut-outs of the wheel cover. Fitting – Fit ...

    See also:

    Assembly overview - input shaft
    Note When installing new sliding gears or a new input shaft, all details of the - Electronic parts catalogue ETKA and technical data must be observed. Install all bearings, synchromeshed ge ...