Seat Leon >> 1.0 l, 1.2 l and 1.4 l TSI engines and 1.6 l MPI engines

SEAT Leon Service and Repair Manual / Maintenance / Description of work / Engine oil and oil filter: replace / 1.0 l, 1.2 l and 1.4 l TSI engines and 1.6 l MPI engines

Special tools and workshop equipment required

  • Puller - 3417-

Maintenance

NOTICE Prevent engine oil from dripping onto components.

Before starting with the generator removal, cover with a cloth.

  • Remove central soundproofing.
  • Unscrew oil filter -arrow- with the puller - 3417- .

NOTICE Observe installation instructions on oil filter! Please observe requirements for disposal.

Maintenance

  • Clean the surface between the seal of the oil filter and the engine.
  • Lightly grease the seal of the new filter.
  • Screw in the new filter by hand and tighten using the puller - 3417- with the specified tightening torque.

Maintenance

At the first oil change, drain the engine oil.

  • Screw out the oil drain plug with the lock seal -1- and discard it.
  • Allow engine oil to drain out.

Maintenance

Please observe requirements for disposal.

  • Screw in the new oil drain plug -3- with a new seal -2- by hand and tighten it with the specified torque.

Maintenance

After the first oil change, drain the engine oil.

  • Screw out the oil drain plug -2- and discard the seal -3-.

NOTICE Continue to use the oil drain plug after the first oil change.

  • Allow engine oil to drain out.

NOTICE Please observe requirements for disposal.

  • Screw in the oil drain plug -2- with a new seal -1- and tighten it with the specified torque.

Maintenance

Maintenance

  • Fit central soundproofing.
  • Top up engine oil.
CAUTION
  • Torque specifications must not be exceeded.
  • Excessive torque can cause leaks in the area of the oil drain plug or even damage.
    Engine oil and oil filter: replace
    CAUTIONFor the Russian market only. Due to climate conditions and fuel quality, the following engine oil must always be used in the Russian market for the 1.8l TSI and 2.0l TSI petro ...

    1.8 l and 2.0 I TSI engines
    Special tools and workshop equipment required Assembly tool - T10549- 32 mm socket wrench Oil spill cloth Remove engine cover. Loosen the oil filter housing -arrow- with a SW 32 mm so ...

    See also:

    Main beam lights
    Fig. 166 Main beam headlights Fig. 167 Main beam headlights – Raise the bonnet – Remove the cover  fig. 166 C by pulling on this. – Remove the connector  fig. 1671 from the b ...